Pass-rail notes: the rehearsal still and the dress-still still had to stay in the same doorway
The pass rail sits just inside the stage-left door, under a work lamp that has not been moved since the get-in. During the first full run, the deputy took a still of the doorway from the rail: the edge of the black, the taped number on the door jamb, and a sliver of the stage floor. Two nights later, at the dress rehearsal, the same deputy took a second still from almost the same spot, this time with the finished costume in the opening. The two frames were meant to sit next to each other in the show report, so the wardrobe team could see how the hem cleared the same door that the rehearsal skirt had cleared.
They did not sit quietly. The dress-still had been taken a half-step closer, and the work lamp sat higher in the frame. A hard cut from the rehearsal still to the dress-still made the doorway jump, as if the jamb itself had been shifted. Nobody had moved the jamb. The jump was only in the photographs.
A straight crop on the dress-still put the lamp back where the rehearsal lamp had been, but it also cut the hem that the wardrobe team needed to see. A pad of black around the rehearsal still made the first frame look like a snapshot dropped onto a blank card. Neither version kept both stills in the same doorway.
What we needed was a short move from the rehearsal still to the dress-still that held the jamb, the taped number, and the work lamp in place, while the costume arrived in the opening. It had to be quiet enough for a PDF report, not a trailer, and it had to be done on the shared office laptop between notes.
I used AI transition between two images for that step. It is a free page in the browser. There is no account to open, and I did not have to install anything on the shared laptop. I uploaded the rehearsal still as the first frame and the dress-still as the last, kept them in the same doorway, and exported a short clip in which the taped number does not wander.
The first export pulled the hem too quickly and made the lamp wobble. I shortened the move and watched only the jamb. When the jamb stayed still, the costume could arrive in the opening without dragging the work lamp up the wall. The third export was the one that went into the report: two seconds, no captions, just the same doorway holding the two nights together.
I left the original stills in the folder, labelled and untouched. The clip sits in a subfolder marked for the report only. The pass rail, the work lamp, and the taped number are still where they were at the get-in. The only change is that the rehearsal still and the dress-still can now be shown in order without the doorway appearing to jump.